Advanced Tubular Technologies, Inc.


Distributor for
North and South America


Distributor for the
United Kingdom

Back to the
VTube-LASER web page


VTube-LASER Knowledgebase

Click on the knowledgebase lightbulb to check out the latest details and versions.

Lightbulb

 

 

For tube support and clamping
read about our tube clamp system available through FARO Technologies

 

 

Copyright © Advanced Tubular Technologies, Inc.
vtube logovideos

Video Contents

Video 1: Measure a 1/2" Automotive AC Tube
Video 2: Start a new project
Video 3: Qualify with Master Data
Video 4: Reverse Engineering
Video 5: Recall Master Data From Benders
Video 6: Effective Tube End Scans
Video 7: Measuring a Bend Radius with the Laser Probe
Video 8: Measuring a Bend Angle while Still in the Bender

Demo of Inspecting a 1/2" Diameter
Automotive Air Conditioner Tube
This demo shows VTube scanning an automotive AC tube with end fittings.

START a NEW PROJECT and ENTER MASTER DATA
Use these simple steps to start a new project in VTube-LASER with a sample 1/4" tube.

QUALIFY with COMPARE to MASTER
This is a training video showing VTube-LASER measuring the 1/4" tube from the project above for comparison to master data.

REVERSE ENGINEERING
VTube-LASER reverse engineering training video.

RECALL MASTER DATA FROM BENDERS ">
VTube-LASER recall master data training video.

EFFECTIVE TUBE END SCAN
Learn VTube-LASER End Scan technique to increase accuracy.

MEASURING a BEND RADIUS with the LASER PROBE
Use the Radius Stripe Scan method (VTube-LASER v1.64 and newer) to measure a bend radius.


IN-PROCESS BEND MEASURING - IN THE BENDER
How to use VTube-LASER to measure a bend still in the bender to allow in-process bend correction.