-
Send data from the measuring center to BLM benders.
-
Recall data from the BLM benders to the measuring center.
-
Respond automatically to requests from the Romer measuring center.
-
Connect to all benders through a network connection.
-
Setup a list of benders that Benderlink should handle (ignoring all other benders not programmed into the list).
-
Indicate specific and unique network locations for each bender.
-
Change the bender number by clicking on the bender number LED.
-
Show each bender's unique bender data converted to Supravision when the bender number is changed.
-
View the data in both BLM and Supravision formats in bender data logs.
-
Print the data logs in both formats to the Windows printer.
-
Select and copy from the logs (using Ctrl-C after a selection).
-
Adjust BLM Tool Position values and the corresponding Tool Position radius values (radii 1 through 6).
-
View the BLM and Supravision TRANSLATION LOGS to see what steps were taken during conversion.
