| TRANSLATION TO/FROM MEASURING CENTERS |
Benderlink is designed to make corrections-loops between measuring
centers and KEINS or CHIYODA benders a snap. Take your part-shape
bender setup from hours down to minutes with the Benderlink system
attached to a tube measuring center. (Note: We've documented actual
cases that prove our claim.)
Supported Measuring Centers:
- Supravision based Measuring Centers (like Romer, Aicon, Romer France, Addison, Axila, Multi Systems)
- Eaton Leonard Vector based Measuring Centers (like Laservision)
|
| STANDARD TCP/IP NETWORK |
Because
of the network capability of Benderlink, all connections use standard
Ethernet cables. This means that your bender can be placed
wherever Ethernet cables are run. In most modern plants, Ethernet
connections can be easily extended everywhere. |
| WIRELESS CONNECTION |
Customers can also choose to purchase an additional wireless Benderlink Modules that communicate through a standard WiFi Network |
| PC-BASED STORAGE |
The
software allows for the storage of bender data on the Benderlink hard
drive. Data can be both RECALLED and SENT. Benderlink also allows
for all 20 channels to stored as one "Block" |
| CORRECTIONS LOOP |
The software also supports full corrections loops between the measuring center and each bender. |
| COMMUNICATION WITH CONTROLS |
Benderlink for Chiyoda and Keins communicates with all types of controls
|
| READ ABOUT BENDERLINK |
|
| BENDERLINK GUARANTEES |
|
| TRANSLATION LOGIC |
Sophisticated
translation logic allows MQ41 operators to insert extra rows of
avoidance moves in the FPB data without confusing measuring centers in
corrections-loops. Data is correctly re-translated when sent to the
bender so that the special avoidance moves are not disturbed. |
| 180 DEGREE BENDS |
Benderlink is the only
bender to measuring center system that automatically handles the 180
degree bend problem when communicating with measuring centers.
(Measuring centers cannot handle bends that approach 180 degrees.) |
| CARRIAGE POSITION |
Benderlink automatically positions the carriage when adjustments are made by the measuring center to the tube lengths. |
| DATA EDITING |
Edit bender data and and view tube shapes at the Benderlink computer. |
| INCLUDED SOFTWARE |
Benderlink also comes with the following software
|
